Peavey IRM 8150 Bedienungsanleitung

1IRM 8150Powered Mixer

10XFMR 4 Ω GND LO HIBalanced(600Ω)4 Ω–+Direct Output to 4Ω SpeakerTransformer Output to 8Ω Speaker(Note: Jumper must be in place.)COM 8 Ω 25V 70V NC8

11XFMR 4 Ω GND LO HIBalanced(600Ω)8 Ω–+Direct Output to Multiple Speakers in Parallel.Total Impedance = 4Ω8 Ω–+

12

13CHANNEL INPUTMAX (1/4")(+ 26 dBV)CHANNEL INPUTMINIMUM (1/4")(-20 dBV)CHANNEL INPUTNOMINAL (1/4")(0 dBV)CHANNEL INPUTMINIMUM (XLR)(GAI

14LIMITED WARRANTY Peavey Electronics Corporation warrants to the original purchaser of this new Architectural Acoustics product that it is free f

15IMPORTANT SAFETY INSTRUCTIONSWARNING: When using electric products, basic cautions should always be followed, including the following.1. Read all sa

16Features and specifications subject to change without notice.A Division of Peavey Electronics Corporation711 A Street / Meridian, MS 39302-2898 / U.

2Thank you for purchasing the Peavey IRM™ 8150 mixer amplifier. This is an eight-channel,easy-to-use, powered mixer.Your IRM™ 8150 features a rugged,

3CHANNEL SECTION:LEVEL (1)Controls the channel output level. This signal is routed via the main bus to the main level control. The channellevel also a

4AUX SEND (6)Controls the channel AUX drive level. This signal is routed to the AUX master control, where AUX send signalsfrom all channels are summed

5TAPE/AUX TO MON (14)Controls the level of tape or AUX IN signal to be sent to the mon. bus. This signal will be mixed with channelmonitor signals.TAP

6LINE INPUT JACK (18)For use with line level signal or compatible high Z microphones equipped with a 1/4" phone plug.NOTE: These input jacks (17

7VENT VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualifiedservice center for repair.WARNING: THE FUSE SHOULD ONL

8SPECIFICATIONSNOTE: All specifications are typical unlessotherwise noted.0 dBV = 1 volt RMS0 dBu = .778 volts RMSAll specs are referenced to nominal

9Output Impedance:100 ohmsMASTERGain:Main: = 20 dBMonitor: = 15 dBTape: = 15 dBAux: = 15 dBMaximum Output Level:Main: = +18 dBV (8.0 V RMS)Monitor: =